NAME OF PARTS
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
●
When the MANUAL AUTO button is
pressed in for more than 10 seconds, the
forced cooling operation will start.
●
The forced cooling operation is used at
the time of installation.
Only for authorized service personnel's
use.
●
When the forced cooling operation starts
by any chance, press the START/STOP
button to stop the operation.
● Please press the button at
DICATOR RESET
3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (green)
6 TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp À ashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 13 "AUTO Restart.)
7 ECONOMY Indicator Lamp (green)
●
ECONOMY indicator lamp lights when
ECONOMY OPERATION is operating.
8 Intake Grille (Fig. 4)
9 Front Panel
0 Air Filter
A AirÀ ow Direction Louver
B Right-Left Louver
(behind AirÀ ow Direction Louver)
C Drain Hose
FILTER IN-
Fig. 5 Remote Controller
D Signal Transmitter
E MODE button
F ECONOMY button
G SLEEP button
H TIMER MODE button
I FAN button
J START/STOP button
K SET button (Vertical)
L SWING button
M SET TEMP. button (
N TIMER SET (
/
O CLOCK ADJUST button
P TEST RUN button
● This button is used when installing the air
conditioner, and should not be used un-
der normal conditions, as it will cause the
indoor unit's thermostat function to oper-
ate incorrectly.
● If this button is pressed during normal op-
eration, the indoor unit will switch to test
operation mode, and the Indoor Unit's
OPERATION Indicator Lamp and TIMER
Indicator Lamp will begin to À ash simulta-
neously.
● To stop the test operation mode, press
the START/STOP button to stop the air
conditioner.
Q RESET button
R Remote Controller Display (Fig.6)
S Temperature SET Display
T Operation Mode Display
U SLEEP TIMER Display
V Transmit Indicator
W Fan Speed Display
X SWING Display
Y Timer Mode Display
Z Clock Display
/
)
) button
5