Pushbutton Functions - Fluke 707 Instruction Sheet

Pushbutton Functions

Pushbutton
D
A
+
D
(Power-on Option)
l
 +
D
(Power-on Option)
A
h i j
B
B C
+
C
ON or OFF button.
A
and D simultaneously to toggle
Press
between the mA output spans.
4 mA to 20 mA = 0 % - 100 % (default)
0 mA to 20 mA = 0 % - 100 % (optional)
The selection is saved until it is changed.
l
D
+
Press
resistor (Hr) on. Default is off.
Press to step through modes:
Source mA
Simulate mA
Measure mA
Loop Power (24 V)
Measure V dc
n
Turn to increase or decrease current output.
Current output can be adjusted at a resolution of
1 A or 100 A. (Default is 1 A.)
To adjust the current in 1 A steps, simply
turn the knob.
To adjust the current in 100 A steps,
in and turn
B
Press to step the current
scale (20 mA).
At full scale, press
25 % of full scale.
B C
Press +
Auto Ramp mode and select a ramp form.
A continuously applied or controlled mA ramping
signal is produced in one of three ramp forms.
e ( ), g (
slow
selected ramp form.
C
Press to start the SpanCheck™ at 0 % of
selected current span, i.e., 0 mA for 0-20 mA span
or 4 mA for 4-20 mA span.
d
is displayed.
Press again for 100 % of selected current span.
Function
simultaneously to turn HART
the knob.
B
to step the current down
simultaneously to enter the
f
fast or (step) identifies the
),
press
up
25 % of full