Advertisement
Important Safety Instructions
1.Read all instructions before use.
2.Save these instructions for later use.
3.Follow all warnings and instructions marked on the
product.
4.Unplug this product from the wall outlet before
cleaning. Clean with a damp cloth using a mild soap
and water solution. (Do not use abrasives or petroleum
based cleaners.)
5.Place this product as close as possible to power source
for quick and easy unplugging. Do not block the power
supply receptacle; it must be possible to conveniently
unplug the power cord.
6.Do not use this product near water.
7.This product should never be placed near or over a
radiator or heat source.
8.Operate from the type of power source indicated on the
marking label. If you are not sure of the type of power
available, consult your dealer or local electricity board.
9.Do not allow anything to rest on the power cord. Do
not place this product where people may walk on the
cord.
10. If an extension cord is used with this product, make
sure that the total of the ampere ratings on the
products plugged into the extension cord do not exceed
the extension cord ampere rating. Also, make sure that
the total of all products plugged into the wall outlet
does not exceed 15 amps.
11. Do not attempt to service this product yourself, as
opening or removing covers may expose you to
dangerous live parts or other risks, and will void the
warranty.
12. Unplug this product and refer servicing to qualified
personnel under the following conditions:
A) When the power cord or plug is damaged or
frayed.
B) If liquid has been spilled on the product.
C) If the product has been exposed to rain.
D) If the product does not operate normally
when the operating instructions are followed.
E) If the product has been dropped or
the casing has been damaged.
13. Keep out of the reach of children.
14. This shredder should be operated
only with an operator in attendance.
Installation
Unpack your new shredder from its shipping
container.
Place the shredder on a table top, desk or the
optional shredder stand. Be sure the selected work
surface is strong enough to support the weight of
the shredder.
To attach the wire form feed guide, tilt the shredder
back until the front feet lift off the table. Angle the
wire form feed guide so one "U" curve fits around
one of the metal tabs. Wrap the other side's "U"
curve around the other metal tab. Set the shredder
down so the front edge of the guide extends one-
half in front of the machine, with the rest of the
guide between the shredder and the table.
Holding the bag support rod horizontally, pull the
bag up through the center of the rod and wrap the
edges of the bag over the rod. To attach the rod to
the machine, squeeze the ends of the rod together
enough (approximately 1-1/2") to fit between the
back feet on the shredder base. From the back of
the machine, slide the rod under the shredder until
it stops. Release the rod to allow it to snap into
place, with the ends resting against the shredder
feet. Make sure the bag does not block output from
the shredder.
When shredding continuous forms, feed paper
between the guide and the shredder into the
shredder throat.
Parts Identification
Front
Wire Form
Feed Guide
Back Feet
Front Feet
Bag Support Rod
Bag
3
Advertisement
