Installation Instructions; Venting Requirements - Whirlpool Duet GGW9200LL1 Use & Care Manual

INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
8 in. or 10 in. pipe wrench
8 in. or 10 in. adjustable
wrench (for gas
connections)
Flat-blade screwdriver
Adjustable wrench that
opens to 1 in. (2.5 cm) or
hex-head socket wrench
(for adjusting dryer feet)
Level
_/4 in. nut driver or socket
wrench
• Knife
• Safety glasses
• Vent clamps
• Pipe-joint compound
resistant to L.R gas
• Caulking gun and
compound (for installing
new exhaust vent)
• Gloves
• Pliers
Parts needed
Check local codes and with gas supplier. Check existing gas
supply, electrical supply and venting. Read "Electrical
Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing parts.
• For close-clearance installations between 31.5 in. (80.01 cm)
and 37 in. (93.98 cm), see "Plan Vent System" section for
venting requirements.
I< 37" >1
(_.aecm)
Mobile home installations require special parts (listed following)
that may be ordered by calling the dealer from whom you
purchased your dryer. For further information, please refer to the
"Assistance or Service" section of this manual.
• Mobile Home Installation Kit. Ask for Part Number 346764.
• Metal exhaust system hardware.
Parts supplied
Remove parts packages from dryer drum. Check that all parts are
included.
• Door Reversal Kit
Pedestal
Are you placing the dryer on a pedestal? You may purchase a
pedestal separately for this dryer. This pedestal will add about
13 in. (33 cm) to the height of your unit for a total height of
approximately 51 in. (130 cm).
• Parts package.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Optional pedestal
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number LAB2700LQ (White), LAB2706LT (Biscuit) or
LAB2700LL (Pewter).
Stack Kit
Are you planning to stack your DUET ¢ washer and dryer? To do
so, you will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number 8541503.