Table of Contents
Advertisement
Available languages
Available languages
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull the storage drawer straight back past the drawer stop
notch and the end of the side rails.
To Replace:
1. Lift up the back of the drawer and place it inside the range in
its fully forward position.
2. Lift up the front of the drawer to a level position.
3. Slowly push the drawer into the range until the drawer side
rails engage with the gap in the drawer glides.
A. Drawer stop notch
B. End of side rail
2. Lift up the back of the drawer and pull the drawer out.
A. Engage drawer glide
4.
Once the drawer is fully engaged on both sides, slide the
drawer back into the closed position.
NOTE: When removing and replacing the storage drawer, a
slight push may be needed to move the drawer stop notch
past the drawer glides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
•
Is the power supply cord unplugged?
Plug into a grounded outlet.
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician
Cooktop
will not operate
•
Is the control knob set correctly?
Push in knob before turning to a setting.
•
On ceramic glass models, is the "Control
Lock" set?
See "Control Lock" section.
Excessive heat around cookware on cooktop
Is the cookware
the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Hot Surface indicator light stays on
•
Does the Hot Surface indicator light stay on after control
knob(s) have been turned off?
See "Cooktop Controls" section.
Cooktop
cooking results not what expected
•
Is the proper cookware being used?
See "Cookware"
section.
•
Is the control knob set to the proper heat level?
See "Cooktop Controls" section.
•
Is the appliance level?
Level the appliance. See the Installation Instructions.
Oven will not operate
•
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
•
Has a delay start been set?
See "Timed Cooking" section.
•
On some models,
is the Control
Lock set?
See "Control Lock" section.
Oven temperature
too high or too low
•
Does the oven temperature
calibration need adjustment?
See "Oven Temperature Control" section.
•
On some models, does the cooling fan run during BAKE,
BROIL or CLEAN?
It is normal for the fan to automatically
run when the oven is
in use. This helps cool the electronic control.
Oven indicator lights flash
•
Do the oven indicator lights flash?
See the "Display" and/or the "Oven Indicator Lights" section.
If the indicator light(s) keeps flashing, call for service. See
"Assistance
or Service" section.
16
Advertisement
Table of Contents
