Troubleshooting - Fellowes POWERSHRED 225Ci Instructions

PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug Locate Auto-start
shredder infared sensor
OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
AUTO
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREvENTIvE MAINTENANCE & ACCESSORIES

TROUBLESHOOTING

A B
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
4
.
3
AUTO
Dip cotton swab in
rubbing alcohol
AUTO
C D
4
AUTO
Using cotton swab, wipe
away any contamination
from the paper sensors
15
A. Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the
door to resume shredding.
B. Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes
waste bag 36054.
C. Remove Paper Indicator: W hen illuminated, press reverse (
Reduce paper quantity to an acceptable amount and refeed into paper entry.
D. SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
and the shredder will stop shredding. If SafeSense
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
ENGLISH
Models 225Ci/225i
) and remove paper.
indicator will illuminate
®
is active for 3 seconds, the shredder will automatically
®