Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Using The Plate Warmer - Whirlpool DU920PWKT0 Use & Care Manual

temperature of the water entering the dishwasher. The cooler the
water, the longer the cycle time. If the water is already hot
enough, the cycle time will be as shown.
Use this cycle for hard-to-
clean, heavily-soiled pots,
pans, casseroles, and
regular tableware.
Use both
detergent
dispenser
sections.
Wash Rinse Main Purae t Final
Wash Rinse
• • • • •
140°F 140°F 140°F
(6ooc) (60oc) (6ooc)
Dry
Time
(rain)
88*
Water
Usage
(gal/L)
9.1/34.4
Use this cycle for heavily-
soiled loads.
Use both
detergent
dispenser
sections.
Wash Rinse Main Purge t Final
Wash Rinse
Dry
Time
(rain)
• • •
140°F
(6ooc)
72*
Water
Usage
(gal/L)
6.9/26.1
Wash
Use this cycle for loads
with normal amounts of
food soil. (The energy-
usage label is based on
this cycle.)
Use
covered
detergent
dispenser
section.
Rinse Main Purge t Final Dry Time
Wash Rinse (rain)
• • • •
62*
140°F
(6ooc)
Water
Usage
(gal/L)
4.8/18.2
Use this cycle for pre- Use
rinsed or lightly-soiled covered
loads, detergent
dispenser
section.
Wash
Rinse Main Purge t Final Dry Time Water
Wash Rinse (rain) Usage
(gal/L)
• • • • 62* 4.8/18.2
Use this rinse cycle for
rinsing dishes, glasses,
and silverware that will
not be washed right away.
Do not use
detergent _
with this
cycle.
Wash Rinse Main Purge t Final Dry Time Water
Wash Rinse (rain) Usage
(gal/L)
• 6 2.2/8.3
A small amount of water runs through the pump to remove soil
particles.
You can cancel a cycle at any time.
1. Turn the Cycle Control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the Cycle Control knob to OFR
If your dishwasher has more than one wash cycle, you can
change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Press a cycle and, if desired, press an option.
3. Turn the Cycle Control knob clockwise.
4. Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE; Turning the Cycle Control knob can cause the covered
Detergent Dispenser section to open and release the
detergent. Check the covered section if the cycle uses
detergent in both sections.
5. Close the door firmly until it latches. The dishwasher starts a
new cycle.
You can add an item anytime before the main wash starts, or the
Cycle Control knob reaches Normal Wash.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
Use the Plate Warmer cycle to warm serving dishes or dinner
plates.
NOTE; Do not use the Air Dry option.
1. Close and latch the door.
2. Turn the Cycle Control knob to PLATE WARMER.
3. Allow 8 minutes for the cycle to heat the dishware.
4. Turn the Cycle Control knob to OFR
12