Table of Contents
Advertisement
Rotary Multi Selector and Improved Gui
Operation has been made smoother, simpler and faster. A new Rotary
multi selector incorporated into the camera back enables high-speed
image browsing with circular scrolling action at up to 10 frames per
second, while a range of buttons built into the Rotary multi selector
make for more intuitive operation.
Using the Fantasea FS-5 housing:
Opening The Housing:
1.
Observe that the locking mechanism has a single spring tab.
2.
Pinch the Latch Buckle Release Tab with one hand. While
pinching the tab, pull the latch open. The latch is hinged on
the front half of the clamshell.
3.
Pulling the latch toward the rear of the housing will unclip the
latching buckle and allow it to swing free--for opening.
Inserting Camera:
Since the Fantasea's FS-5 was specifically designed for the
Coolpix S5 digital camera, insertion is a simple matter of placing
the camera in the housing.
1.
Make sure the camera lens is centered in the rounded port area
and that the lens does not distort the round black rubber seat.
The housing is designed to have the camera fit in place perfectly,
but if you are not careful, it is possible to put it in at an improper
angle and hence it will be impossible to get a good seal or easy
closure of the housing.
2. After camera insertion, be sure that the extended camera lens
does not catch or bend the black rubber seat on the inside of the
lens port. It is vital that the lens does not disturb this rubber seat.
1.
Notes:
2.
It is recommended to make some camera settings
prior to inserting into the housing. Please refer to
the Coolpix owner's manual for menu options and
personal preferences to choose from.
Take a few test shots: it is recommended to turn
the camera "on" and program to "Flash Always"
mode before inserting into housing and then take
test shots to make sure all systems are working.
8 8
Advertisement
Table of Contents
