Installation Instructions; Optienal Pedestal; Electrical Requirements; Venting Requirements - Whirlpool Duet GGW9200LW0 Use & Care Manual

INSTALLATION
INSTRUCTIONS
Mobile home installations require special parts (listed following)
that may be ordered by calling the dealer from whom you
purchased your dryer. For further information, please refer to the
"Assistance or Service" section of this manual.
• Mobile Home Installation Kit. Ask for Part Number 346764.
• Metal exhaust system hardware.
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
• 8in. orl0in, pipewrench • Knife
• 8 in. or 10 in. adjustable • Safety glasses
wrench (for gas
connections) • Vent clamps
• Flat-blade screwdriver • Pipe-joint compound
resistant to L.R gas
• Adjustable wrench that • Caulking gun and
opens to 1 in. (2.5 cm) or compound (for installing
hex-head socket wrench
new exhaust vent)
(for adjusting dryer feet)
• Level • Gloves
• v4in. nut driver or socket • Pliers
wrench
Parts supplied
Remove parts packages from dryer drum. Check that all parts are
included.
• Door Reversal Kit
• Parts package.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes and with gas supplier. Check existing gas
supply, electrical supply and venting. Read "Electrical
Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing parts.
• For close-clearance installations between 31.5 in. (80.01 cm)
and 37 in. (93.98 cm), see "Plan Vent System" section for
venting requirements.
I_- 37" 91
(93.98 cm)
Are you placing the dryer on a pedestal? You may purchase a
pedestal separately for this dryer. This pedestal will add about
13 in. (33 cm) to the height of your unit for a total height of
approximately 51 in. (130 cm).
Optional pedestal
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number LAB2700LQ (White) or LAB2700LT (Biscuit).
E×piosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at teast 18 inches (46 era) above the
floor for a garage installation.
FaiJure to do so can result in death, explosion,
or fire.
You will need
• A location that allows for proper exhaust installation. A gas
dryer must be exhausted to the outdoors. See "Venting
Requirements."
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
• A sturdy floor to support the total dryer weight of 200 Ibs
(90.7 kg). The combined weight of a companion appliance
should also be considered.