Whirlpool Duet GGW9200LW0 Use & Care Manual page 4

iMPORTANT SAFETY iNSTRUCTiONS
WARNUNG:
To reduce the risk of fire, eHectric shock, or injury to persons when using the dryer, follow basic
precautions, incHuding the following:
m
m
Read aH instructions before using the dryer.
Do not pHace items exposed to cooking oiHs in
your dryer. Items contaminated with cooking oiHs
may contribute to a chemicaH reaction that couHd
cause a Hoadto catch fire.
Do not dry articles that have been previousHy
cleaned in, washed in, soaked in, or spotted with
gasoHine, dry-cHeaning soHvents, other fiammaMe,
or expHosive substances as they give off vapors
that couHd ignite or explode.
Do not allow children to play on or in the dryer.
Close supervision of children is necessary when
the dryer is used near children.
Before the dryer is removed from service or dis-
carded, remove the door to the drying compart
ment.
Do not reach into the dryer if the drum is moving.
Do not install or store the dryer where it will be
exposed to the weather.
Do not tamper with controls.
Do not repair or replace any part of the dryer or
attempt any servicing unless specifically recom-
mended in this Use and Care Guide or in published
user-repair instructions that you understand and have
the skills to carry out.
Do not use fabric softeners or products to eliminate
static unless recommended by the manufacturer of
the fabric softener or product.
Do not use heat to dry articles containing foam rubber
or similarly textured rubber like materials.
Clean lint screen before or after each load.
Keep area around the exhaust opening and adjacent
surrounding areas free from the accumulation of lint,
dust, and dirt.
,, The interior of the dryer and exhaust vent should be
cleaned periodically by qualified service personnel.
,, See installation instructions for grounding require
ments.
SAVE THESE iNSTRUCTiONS
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223,1/NFPA 54 or the CAN/CSA-B149, Installation Codes,
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22,1,