14, Route the Arm CaMe (54) over a "V"opuHey (46),
Attach the "V"opuHey, a Large CaMe Trap (50),
two Full Finger Guards (41), and an MIO Washer
(57) to the Upright (3) with an MIO x 63mm BoUt
(75) and an MIO NyUonLocknut (56), Make sure
the Cable Trap is oriented
to hold the Cable in
the groove of the "V"-puttey.
15, Route the Arm CaMe (54) under a 90mm Pulley
(48), Attach the Pulley and two HaUl Finger
Guards (43) to the DouMe "U"oBracket (63) with
an MIO x 48mm BoUt(81) and an MIO NyUon
Locknut (58), Make sure the Finger Guards are
on the outside
of the "U"-bracket
as shown.
16, Route the Arm CaMe (54) over a "V"opuHey (46),
Attach the "V"opuHey, a Large CaMe Trap (50),
two Full Finger Guards (41), and an MIO Washer
(57) to the Upright (3) with an MIO x 63mm BoUt
(75) and an MIO NyUonLocknut (56), Make sure
the Cable Trap is oriented
to hoJd the Cable in
the groove of the "V"-pultey.
17, Grease an M8 x 22mm ShouUder BoUt(65), Attach
the Arm CaMe (54) to the indicated Cable Pivot
(39) with the Bolt and an M8 Nylon Locknut (58),
14
15
16
17
81
75
50
46
6
5O
41
75
11