Exmark Lazer Z Operator's Manual page 31

No. 6 (Mule Drive Belt Idler Arm)
Located Under Deck
No. 7 (Pump Drive Belt Idler Arm)
Located Under Deck
No. 4,6, & 7 (Idler Pivots, Mower Deck) Monthly
disassemble belt and spring and grease under a
"No Load" condition.
c) Lubricate front caster pivots once a year. Remove hex plug and cap.
Thread grease zerk in hole and pump with grease until it oozes out
around top bearing. Remove grease zerk and thread plug back in. Place cap
back on.
5.1.16 Lubricate seat switch actuator: (All units except for Kohler 26 HP EFI)
a) Stop engine and remove key.
b) Tilt seat up.
c) Lubricate switch actuator rod with spray type lubricant or light oil.
5.1.17 Lubricate brake handle pivot:
a) Stop engine and remove key.
b) Lubricate bronze bushings on brake handle pivot with a spray type lubricant
or light oil.
5.1.18 Lubricate brake rod bushings:
a) Stop engine and remove key.
b) Tilt seat up.
c) Lubricate bronze bushings on each end of brake rod shaft with a spray type
lubricant or a light oil (bushings are located to the inside of the flange bearings).
5.1.19 Lubricate motion control bronze bushings:
a) Stop engine and remove key.
b) Tilt seat up.
c) Lubricate bronze bushings on flange bearings securing the motion control
arm shafts with a light oil or a spray type lubricant.
5.1.20 Remove engine shrouds and clean cooling fins (Kohler Air-cooled units only):
a) Stop engine and remove key.
b) Remove cooling shrouds from engine and clean cooling fins. Also clean dust,
dirt and oil from external surfaces of engine which can cause improper cooling.
c) Make sure cooling shrouds are reinstalled. Operating the engine without
cooling shrouds will cause engine damage due to overheating.
Service Interval: 160 hrs.
Service Interval: 160 hrs.
Service Interval: 160 hrs.
Service Interval: 160 hrs.
Service Interval: 80 hrs.
- - 26