Exmark Lazer Z Operator's Manual page 30

5.1.12 Check tire pressures:
a) Stop engine and remove key.
b) Inflate all four tires to 13 psi (90 kPa).
5.1.13 Check battery electrolyte level:
a) Stop engine and remove key.
b) Tilt seat up.
c) Remove vent caps from battery. Fill with water (distilled is recommended)
to bottom of vent wells and replace vent caps.
d) See Assembly Section 3.8, for servicing a new battery.
PART NO. 513747
5.1.14 Check condition of belts:
a) Stop engine and remove key.
b) Tilt seat up. Lift the rubber flap on front side of the engine to check
pump drive belt.
c) Remove left and right belt shields on deck and lift up floor pan to inspect
deck drive belt.
d) Check under machine to inspect the mule drive belt.
e) Check alternator drive belt behind engine (Kawasaki Liquid-cooled units only)
f) See Sections 5.2.3, through 5.2.6 for belt adjustment.
5.1.15 Lubricate grease fittings:
a) Stop engine and remove key.
b) Lubricate fittings with one to two pumps of SAE No. 2 multi-purpose
gun grease.
Refer to the following chart for fitting locations and lubrication schedule.
FITTING
LOCATIONS
1. Front Casters
2. Front Caster Pivots
3. Height Adj. Shaft Bearings
4. Deck Drive Belt Idler Arm
5. Brake Brackets
6. Mule Drive Belt Idler Arm
7. Pump Drive Belt Idler Arm
8. Deck Rear Struts
More often if operating under severe conditions.
See 5.1.15 Section c) for special lubrication instructions.
Service Interval: 40 hrs.
Service Interval: 40 hrs.
LOCATION: Top Center of Console
Under Front of Seat
Service Interval: 40 hrs.
Service Interval: Refer to chart.
LUBRICATION CHART
INITIAL
PUMPS
2
0
1
1
1
1
1
1
- - 25
NO. of SERVICE
PLACES INTERVAL
2 40 hours
2
5 40 hours
1 40 hours
2 200 hours
1 40 hours
1 40 hours
2 40 hours
yearly