Troy-Bilt TB154 Operator's Manual page 6

Using the Cord Retainer
An extension cord retainer is suspended on the cord guide bar
found on the upper handle.
NOTE: Do not plug your extension cord into the power
source receptable (outlet) prior to routing it through the
cord retainer and connecting the extension cord to the
cultivator's cord outlet receptacle.
To properly route your extension cord through the cord
retainer:
1. Approximately eight inches from its end, crease your
extension cord to form a tight loop.
2. Push the loop through the bottom hole in the cord retainer
(Fig. 3).
NOTE: Use a UL-approved extension cord. A 100-foot, 14-
gauge cord is recommended. A 5g-foot, 16gauge cord is
acceptable. Refer to the small chart found on Page 3.
The cord retainer and the guide bar work together to secure
your extension cord and safely limit its movement.
The cord retainer (with the extension cord) will slide along the guide
bar as the cultivator is moved to the left or to the right (Fig. 5).
/ /
iij
Fig. 5
Fig. 3
3. Position the loop over the clip found on the cord retainer
and pull down until the cord fits snugly into the clip (Fig. 4).
Fig. 4
6