Relay Pcb Ass'y; Gear; Idler Arm - Toshiba MD13P3 Service Manual

DISASSEMBLY INSTRUCTIONS
NOTE
1, After the assembly of the Rack Feed, check if the Rack
Feed 1/2 is moving smoothly. (Refer to Fig. 2-7-B)
2, In case of the Rack Feed Ass'y installation, install cor-
rectly as Fig. 2-7-C,
Moving smoothly
Fig. 2-7-B
2-8: RELAY PCB ASS'Y (Refer to Fig. 2-8-A)
1, Remove the screw ,it,
2, Remove the Relay PCB Ass'y.
• Screw Torque: 4 ± O 5kgf,cm !")
Fig. 2-8-A
NOTE
1, When installing the wire of the Relay PCB, install it
correctly as Fig. 2-8-B,
2-9: GEAR (Refer to Fig. 2-9-A)
1. Un ock the support
2. Remove the Middle Gear 1/2/3, Idler Gear and Feed Gear,
Middle Gear 2
M_ddle Gear 3 4
dler Gear
Malr_ Ch_
Fig. 2-9-A
NOTE
1. In case of the Idler Gear installation, install correctly as
Fig. 2-9-B.
2. When installing the Middle Gear 2, check if the Middle
Gear 2 is locked correctly as Fig. 2-9-C.
[OK] diet Gear [NG] dietGear
[- "] I
diet Arm Idle An1!
Fig. 2-9-B
Check LOCk
Mddle Gear2
Fig. 2-9-C
2-10: IDLER ARM (Refer to Fig. 2-10)
1. Remove the Idler Arm.
_ush
FEE0 _,_OTOR.
Fig. 2-8-B
idler Arm
B2-3
Fig. 2-10