DISASSEMBLY
INSTRUCTIONS
2. REMOVAL
OF DVD DECK PARTS
NOTE
1, Do not disassemble
the DVD DECK PARTS except listed
parts here, Minute adjustments
are needed if the disas-
semble is done. If the repair is needed except listed parts,
replace the DVD MECHAASS'Y,
2-1 : TRAY (Refer to Fig. 2-1-A)
1, Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
2, Unlock the support 1 and remove the Tray.
\
Mair_
ran!e Ass'y
Fig. 2-1-A
NOTE
1, In case of the Tray installation,
install them as the circled
section of Fig. 2-1-B so that the each markers are met.
Ma;n Chsssis
Assy
/
Malr_
ran!e Ass'y
2-3: RACK LOADINGIMAIN
GEAR/RACK
LOADING
SPRING! RACK L SPRING (Refer to Fig. 2-3)
1. Remove the Rack L Spring.
2. Press down the catcher [! and slide the Rack Loading.
3. Remove the Rack Loading, Rack Loading Spring and
Main Gear.
ManF,ame A ss'y
Fig. 2-1-B
2-2: MAIN CHASSIS ASS'Y (Refer to Fig. 2-2-A)
1, Remove the Main Chassis Ass'y from the insulator (R),
2, Unlock the support 1,
3, Remove the Main Chassis Ass'y.
{nsulator(R)
Fig. 2-2-A
NOTE
1, In case of the Main Chassis Ass'y, install it from (1) to (6)
in order. (Refer to Fig. 2-2-B)
Y
/
Fig. 213
2-4: CLAMPER ASS'Y!INSULATOR(R)ILEVER
SWITCH
(Refer to Fig. 2.4_A)
1. Remove the screw 1.
2. Remove the Lever Switch.
3. Remove the 2 Insulator (R).
4. Press the Clamper and rotate the Clamper Plate clockwise,
then unlock the 3 supports 2.
5. Remove the Clamper Plate, Clamper Magnet and Clamper.
B2-1
Fig. 2-4-A