Disassembly Instructions; Removal Of Mechanical Parts And P.c. Boards; Crt Pcb; Dvd Block - Toshiba MD13P3 Service Manual

DISASSEMBLY INSTRUCTIONS
1. REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
1-1 : BACK CABINET (Refer to Fig. 1-1)
1, Remove the 4 screws ,i),
2, Remove the screw z which are used for holding the Back
Cabinet.
3. Remove the AC cord from the AC cord hook _.
4, Remove the Back Cabinet in the direction of arrow,
Fror_i Cabinei
Fig. 1-1
1-2: CRT PCB (Refer to Fig. 1-2)
CAUTION: BEFORE REMOVING THE ANODE CAP,
DISCHARGE ELECTRICITY BECAUSE IT
CONTAINS HIGH VOLTAGE.
BEFORE ATTEMPTING TO REMOVE OR
REPAIR ANY PCB, UNPLUG THE POWER
CORD FROM THE AC SOURCE.
1, Remove the Anode Cap.
(Refer to REMOVAL OF ANODE CAP)
2, Disconnect the following connector:
(CP801).
3, Remove the CRT PCB in the direction of arrow.
F='or_i Cabinei
CRT PCB
Fig. 1-2
1-3: AM PCB/DVD BLOCK (Refer to Fig. 1-3)
1. Remove the 2 screws 1i.
2. Disconnect the following connectors:
(CP301, CP302, CP401 and CP3800).
3. Remove the AV PCB/DVD Block in the direction of arrow,
Front Cabinet
AV PCB/_.)VD Block
Fig. 1-3
1-4: DVD BLOCK (Refer to Fig. 1-4)
1. Remove the 11 screws i.
2. Remove the Top Shield in the direction of arrow (A).
3. Disconnect the following connectors:
(CP8001 and CP8002).
4. Remove the 4 screws '_.
5. Remove the DVD Block in the direction of arrow (B).
6. Remove the screw ,_).
7. Remove the Jack Shield.
8. Remove the AV PCB in the direction of arrow (C),
®
_ito,. Pixie Fig. 1-4
B1-1