Table of Contents
Advertisement
I
_
INTRODUCTION
Programming
the Remote
Control
p.
€.)
o
p.
z
TV/CA BLE/
VCR ,;witch
I
ADV/
FA
VA
STOP
SOURCE
PLAY
PiP
REC
TMNCR
REW
FF
STLL
LOCATE
SWAP
TOSHIBA
RECALL
POWER
Number
buttons
For future
reference, write the code "
number
you set.-,,,,
_-
.B
VCR CODE:
CABLE CODE:
Note:
You
have to reprogram
the Remote
Control
when
you
change
its batteries.
m
• This Remote Control is programmed
to operate -I-OSHIBA VCRs.
• To operate VCRs (or Cable converters)
other than TOSHIBA models,
perform
the following
procedures
before operating.
Refer to the "VCR code table" (or "Cable TV con verter code: table"
on pages 16 and 17 to find the code number
that corresponds
to the
brand name of your VCR (or your converter).
If more than one number
is listed, try each one separately
L_ntil you
find the one that works.
Set the TV/CABLE/VCR
switch to "VCR" (or "CABLE").
3
4
While holding down RECALL, press the Number buttons to enter
the three digit code number
for your brand XSt: VCR (or converter).
Point the Remote Control at the VCR (or at the converter)
and press
POWER to test the code number.
--If the number
is correct, the VCR should turn on.
---If the VCR does not respond to the Remote Control,
repeat steps
1 through
4 with another code number.
Notes:
• Some newer VCRs are capable of working
on either of two remote
codes. These VCRs have a switch
labeled "VCR "I/V(;R 2."
If your VCR has this kind of switch,
and does not respond to any o]
the code numbers for your VCR brand name, set the switch to the
other position
("VCR 1" or "VCR 2") and reprogram
the Remote
Control.
• In some rare cases, you may not be able to operate your non-
TOSHIBA equipment
with the supplied
Remote Cortrol.
This is;
because your equipment
may use a code that is no1 provided
with
this Remote Control. In this case, please use the equipment's
own
remote control.
15
Advertisement
Table of Contents
