Advertisement
I-,-
o
o
I--
z
o !
TOSHIBA
For future
reference;, write the code
number
you set,
VCR CODE:
CABLE CODE:
Note:
You
have to reprogram
the Remote
Control
when
you change
its batteries.
• This Remote Control is programmed
to operate -[oshib, a VCRs.
• To operate VCRs (or Cable converters)
other than Toshiba
models,
perform
the following
procedures
before operating
Refer to the "VCR code table" (or "Cable TV converter
code table'3
on pages 16 and 17 to find the code number tqat corresponds
to the
brand name of your VCR (or your converter).
2
If more
than
one number
is listed,
try each one separately
untl
you
find
the one that works.
Set the TV/CABLE/VCR
switch to "VCR"
(or "CABLE").
3
4
While holding down RECALL, press the Number buttons to enter
the three digit code number for your brand of VCR (or converter).
Point
the Remote
Control
at the VCR (or at the converter)
and press
POWER
to test the code
number.
--If
the number
is correct,
the VCR should
turn
on.
--If
the VCR does
not respond
to the Remote
Control,
repeat
steps
1 through
4 with
another
code
number,
Notes:
• Some newer VCRs are capable of working
on either of two remote
codes. These VCRs have a switch labeled "VCR 1/VCR 2."
If your VCR has this kind of switch, and does not respond to any of
the code numbers
for your VCR brand name, set the switch to the
other position
("VCR 1" or "VCR 2") and reprograrn
the Remote
Control.
• In some rare cases, you may not be able to operate your non-
TOSHIBA equipment
with the supplied
Remote Control. This is
because your equipment
may use a code that is not provided
wi[h
this Remote Control.
In this case, please use the equipment's
own
remote control.
15
Advertisement
