Table of Contents
Advertisement
Systems Indicator Monitor/ HourMeter
Battery
42.0
,co
PTO
(Blade Engage)
ParkingBrake
o
(®) o
LCD
When the ignition key is rotated out of the STOP
position but not into the START position, the systems
indicator monitor displays the battery's output, in volts,
on its LCD for approximately five seconds, after which it
displays the hours of tractor operation. Once the tractor
is started, the monitor continually displays the hours of
tractor operation on its LCD.
NOTE:
Hours of tractor operation are recorded any
time the ignition key is rotated out of the STOP position.
regardless of whether the engine is started.
The Indicator Monitor will also remind the operator of
maintenance intervals for changing the engine oil. The
LCD will alternately flash the recorded hours, "CHG"
and "OIL" for five minutes, after every 50 hours of
recorded operation elapse. The maintenance interval
lasts for two hours (from 50-52, 100-102, 150-152,
etc.). The LCD will also flash as described above for
five minutes every time the tractor's engine has been
started during this maintenance interval. Before the
interval expires, change the crankcase oil as instructed
on page 23 of this manual.
Brake
If the Brake light illuminates when attempting to start
the tractor's engine, press the brake pedal.
PTO(Blade Engage)
If the PTO light illuminates when attempting to start the
tractor's engine, move the PTO lever into the
disengaged (OFF) position.
Battery
It is normal for the Battery light to illuminate while the
engine is cranking during start-up, but if it illuminate's
during operation, while the engine is running, the
battery is in need of a charge or the engine's charging
system is not generating sufficient amperage. Refer to
the MAINTAIHING YOUR LAWN TRACTOR section of this
manual for the proper battery charging procedure or
have the charging system checked by an authorized
Toro service dealer.
PTO(BladeEngage) Lever
ON ,it
I
OFF
!
PTO
PTO
/BLADE
ENGAGE
The PTO (Blacle Engage) lever is located on the left
side of the dash, next to the steering wheel. Move the
PTO (Blade Engage)lever
forward to engage the
power to the cutting deck or other (separately available)
attachments; move the PTO (Blade Engage) lever
rearward to disengage the power to the attachments.
NOTE:
The PTO (Blade Engage) lever must be in the
disengaged (OFF) position when starting the engine.
CruiseControl L ever
The cruise control lever is located on
the tractordashpanel,
belowthe
;ill
I
steering wheel. Push the cruise
control lever downward while
traveling forward at a desired speed.
While holding the lever down, release
pressure from the drive pedal.
This will engage the cruise control
and allow the tractor to remain at that
speed without applying pressure to
the drive pedal. Depress the brake
pedal or the drive pedal to deactivate cruise control.
Refer to page 17 for detailed instructions regarding
cruise control.
NOTE:
Cruise control cannot be engaged
at the
tractor's fastest ground speed. If the operator should
attempt
to
do so,
the
tractor
will
automatically
decelerate to the fastest optimal mowing ground speed.
ParkingBrakeLever
To set the parking brake, fully
depress the brake pedal and push the
parking brake lever down. Hold the
lever down while taking your foot off
the brake pedal. Both the parking
lever and the brake pedal will then
stay depressed. To release the
parking brake, depress the brake
pedal slightly. The parking brake
lever will then return to its original
position.
IMPORTANT:Always set the parking brake when
leaving the tractor unattended.
15
Hide quick links:
Advertisement
Table of Contents
