Advertisement
You can operate
a connected
cable box with the
supplied
remote commander.
Before operating,
set the
manufacturer's
code number.
3
Use the projection
TV control
buttons
(POWER, 0 - 9, ENTER, JUMP and CH +/-) to
operate
the cable box.
POWER
@®®
®®®
®®
JUMP
CH
0-9 buttons--
ENTER ....
[--I
[--I
I---I
POWER
rn O E3 O r7
OOO[
0001
oooI
JUMP
1--1 _
CH +/-
TV/CABLE
BOX
1
Set the TVICABLE BOX selector
to CABLE
BOX.
TV CABLE BOX
2
While pressing
CODE SET, press 0 - 9 to
enter the manufacturer's
code number
(see
the chart below)
and press ENTER. For
example,
to operate
a Zenith cable box,
press 6 and 8 and press ENTER.
To operate
the projection
TV
Set the TV/CABLE
BOX selector to TV. Then use the
projection
TV control buttons
to control the projection
TV.
For more details
on operating
the cable box
Refer to the operating
instructions
that come with the
cable box.
Manufacturers
and code numbers
(cable box)
Manufacturer
Code number
JERROLD
60, 61, 62, 63, 64, 65, 73
PIONEER
69, 70
SCIENTIFIC
ATLANTA
66, 67
TOCOM
71, 72
ZENITH
68
Notes
• If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, your equipment
may use a code that is not
provided
with this remote commander and you may not be
able to operate your cable box with the supplied remote
commander.
In this case, use the equipment's
own remote
control unit.
• When you remove the batteries from the remote commander,
the code may be erased.
Reset the code each time you replace
the batteries, if necessary.
36 I
Operations
Advertisement
