Sony CDP-CX235 Operating Instructions Manual page 5

Hookups
When connecting the audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections finrtly to avoid
hum and noise.
Amplifier
CD player ,_
• if you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the componont via the DIGITAL OUT (O_ICAL)
connector using an optical cable (not supplied). Tako off the
cap and plug in the optical cable.
POC-15
Optical cable (not supplied)
CD player Digital component
Note
When you coPa_ect via the DIGITAL OUT (O_ICAL)
connector, noise may occur when you play CD software
other than music, such as a CD_ROM.
*(_lf you a Sonycomponent CONTROL
have with the
A1]I jack
Connect the component via the CONTROL A1 II jack.
You can simplify the operation of audio systems
composed of _parate Sony components. For details, refer
to the supplementary "CONTROL A1 II Control System"
instructions.
*_ When using another Sony CD p;iay_ _et_e_ _i_ ;
this player
You can mako the supplied remote effective only for this
player.
• When using the player equipped with the
COMMAND MODE selector:
Set the COMMAND MODE selector of this player to
CD 1 and that of another player to CD 2 or CD 3. Then
set the CD 1/2/3 switch on the remote supplied for
each player accordingly.
• When using the player not equipped with the
COMMAND MODE selector:
The command mode of the player without the
COMMAND MODE selector is _t to CD 1. Set the
COMMAND MODE selector of this player to CD 2,
and set tho CD 1/2/3 switch on the remote to CD 2.
Setting the voltage selector (voltage
selector equipped models only)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.
110- 120V' 1 i- 220- 240 V
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Note on placement
Be sure to place the player on a horizontal place.
If the player is slanted, it may cause malfunction or
damage the player.
Otl i i i
5