Section 6: Service; Troubleshooting; Motor And Electrical; Spray Booth Operations - Grizzly G0533 Owner's Manual

SEcTiON 6: SERvicE

review the troubleshooting and procedures in this section to fix or adjust your machine if a problem devel-
ops. if you need replacement parts or you are unsure of your repair skills, then feel free to call our technical
support at (570) 546-9663.

Motor and Electrical

SYMPTOM
reduced performance with new filters.
Motor producing unusual noise or
vibrations.

Spray Booth Operations

SYMPTOM
too little airflow in booth.
too much airflow in booth.
the filter indicator does not work
properly.
Model g0533 (Mfg. since 3/11)

Troubleshooting

POSSiBLE cAUSE
1. paint build-up on exhaust fan blades
or exhaust duct.
1. Motor mounting hardware loose or
fan loose.
POSSiBLE cAUSE
1. the filter is dirty.
2. obstructions exist in front of the
filters.
3. Filters do not meet design
specifications.
4. Fan is dirty.
5. Filters not installed correctly.
1. Filters are not correctly seated.
1. Fluid level is low.
2. obstructions exist in hoses.
3. air filter indicator is not level.
POSSiBLE SOLUTiON
1. Check exhaust fan blades and
exhaust duct and, if needed, clean
with heavy-duty paint remover.
1. tighten motor mounting hardware.
tighten fan.
POSSiBLE SOLUTiON
1. Change the filters.
2. remove obstructions.
3. Change filters to meet correct
specifications.
4. Clean fan.
5. Make sure all filters are installed and
properly seated.
1. Make sure all filters are installed and
properly seated.
1. Check fluid level and add fluid as
needed.
2. remove obstructions from hoses.
3. loosen manometer mounting
hardware, level using sight glass,
and tighten mounting hardware.
-21-