Section 6: Service; About Service; Troubleshooting - Grizzly G0533 Owner's Manual

SECTION 6: SERVICE

Review the troubleshooting and procedures in this section to fix your machine if a problem develops. If you
need replacement parts or you are unsure of your repair skills, then feel free to call our Technical Support
at (570) 546-9663.
Motor and Electrical
SYMPTOM
Reduced performance with new filters.
Motor producing unusual noise or vibra-
tions.
Spray Booth Operations
SYMPTOM
Too little airflow in booth.
Too much airflow in booth.
The filter indicator does not work prop-
erly.
G0533 3HP Dry Spray Booth

About Service

Troubleshooting

POSSIBLE CAUSE
1. Paint build-up on exhaust fan blades or
exhaust duct.
1. Motor mounting hardware loose or fan
loose.
POSSIBLE CAUSE
1. The filter is dirty.
2. Obstructions exist in front of the filters.
3. Filters do not meet design specifica-
tions.
4. Fan is dirty.
5. Filters not installed correctly.
1. Filters are not correctly seated.
1. Fluid level is low.
2. Obstructions exist in hoses.
3. Air filter indicator is not level.
POSSIBLE SOLUTION
1. Check exhaust fan blades and exhaust
duct and, if needed, clean with heavy-
duty paint remover.
1. Tighten motor mounting hardware.
Tighten fan.
POSSIBLE SOLUTION
1. Change the filters.
2. Remove obstructions.
3. Change filters to meet correct specifi-
cations.
4. Clean fan.
5. Make sure all filters are installed and
properly seated.
1. Make sure all filters are installed and
properly seated.
1. Check fluid level and add fluid as
needed.
2. Remove obstructions from hoses.
3. Loosen manometer mounting hard-
ware, level using sight glass, and tight-
en mounting hardware.
-21-