Channel Menu - Samsung UN55B8000 User Manual

You c an configure various settings for y our TV channels with f eatures such as Auto P rogram, Favorite Channels, and S ignal
Strength.
Channel Menu
[]
[]
[]
[]
[]
Antenna _ Air / Cable
Before your television can begin memorizing the available channels, you must specify the type
of signal source that is connected to the TV (i.e. an Air or a Cable system).
__ Press the TOOLS button to display the Tools menu. You can also set the Antenna by
selecting Tools _ Switch to Cable (or Switch to Air).
Auto Program
Air: Air antenna signal, / Cable: Cable antenna signal. / Auto: Air and Cable antenna
signals
When selecting the Cable TV system: Selects the cable system. STD, NRC and IRC identify various types of cable TV
systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point
the signal source has been selected.
After all the available channels are stored, it starts to remove scrambled channels (Removing scrambled channel). The Auto
program menu then reappears.
If you want to stop Auto Programming, press the ENTER E} , ,Jbutton. The Stop Auto Program? message will be displayed.
Select Yes by pressing the 4 or _. button, then press the ENTER _ button.
Clear Scrambled Channel (digital channels only)
This function is used to filter out scrambled channels after Auto Program is completed. This process may take up to 20--30
minutes.
To stop searching scrambled channels: Press the ENTER _ button to select Stop. Press the _ button to select Yes, then
press the ENTERIB_ button.
This function is only available in Cable mode.
Channel List
For detailed procedures on using the Channel List, refer to the 'Managing Channels' instructions. (see pages 15~16)
You can select these options by simply pressing the CH LIST button on the remote control.
Fine Tune (analog channels only)
Use fine tuning to manually adjust a particular channel for optimal reception.
If you do not store the fine-tuned channel in memory, adjustments are not saved.
'*' will appear next to the name of fine-tuned channels.
To reset the fine tuning setting, press the T button to select Reset, then press the ENTER _,_ button.