Time, Monday Through Saturday - Eureka 5740 series Owner's Manual

NOTE: Turn off the switch and unplug the electrical cord before servicing.
PROBLEM
Motor will not start.
Motor suddenly stops.
Does not clean the carpet
or floor.
No suction at the end of hose.
Headlight not working.
Noise from the brush roll
area.
Cleaner is hard to push.
Cleaner height knob will
not turn.
Dust cup will not go into cleaner.
Hood will not come off.
Missing parts.
Questions?
16
CAUSE
3
Electric Plug
3
Thermal Cut Off
3
Filters
3
Dust Cup
3
Hose
3
Belt
3
Brush Roll
3
Hose Adapter
3
Filters
3
Hose
3
Dust Cup
3
Light Bulb
3
Brush Roll
3
Belt
3
Cleaner Height Setting
3
Belt
3
Cleaner Height
Setting
3
Dust Cup Lid Assembled
Properly
3
Cleaner Height Setting
3
Screws
SOLUTION
Push plug securely into outlet.
Try another outlet.
Check circuit breaker.
Page 6.
Clean or replace the filters. Hint: If picking up fine
dust, the filters may not look dirty but a fine substance
tends to reduce suction when it blocks the airflow
through the filter(s).
Be sure the dust cup is properly seated into the cleaner
body. Page 10.
Empty dust cup. Page 10.
Be sure hose adapter is secure on back of cleaner.
Page 15.
Remove any blockages from the hose that restrict the
airflow. Page 15.
Check base hose and long hose. Page 15.
Replace a broken, cut, loose or out of shape belt.
Clean hair and thread from bristles and end cap area.
Replace brush roll if bristles are worn.
Be sure hose adapter is secure. Page 15.
Clean or replace the filters. Hint: If picking up fine
dust, the filters may not look dirty, but a fine substance
tends to reduce suction when it blocks the airflow
through the filters.
Remove any clogs from the hose that restrict the
airflow. Check base hose and long hose. Page 15.
Empty dust cup.
Replace light bulb. Page 14.
Remove hood and clean debris or items from the brush
roll area.
Replace a broken, cut, loose or out of shape belt.
Page 13.
Put handle in operating position. Tilt the cleaner back
to raise the front wheels off floor. Then turn the knob to
a higher setting.
Replace a broken, cut, loose or out of shape belt.
Page 13.
Hint: Put handle in operating position. Tilt the cleaner
back to raise the front wheels off floor. Then turn the
knob.
Filter has to be installed in dust cup or dust cup will not
go into cleaner.
Hood cannot be removed from cleaner unless the
cleaner height setting is in the lowest or highest position.
All three screws must be removed from the top of the
hood. Page 13.
Call 1-800-438-7352 between 8:00 a.m. and 4:45 p.m.,
central standard time, Monday through Friday. Know the
model and serial numbers when you call.
Call 1-800-282-2886 between 7 a.m. to 8:00 p.m.,
central standard time, Monday through Saturday. Know
the model and serial numbers when you call.