Eureka 5740 series Owner's Manual page 15

To Clear Blockages in Hose
NOTE:Turn off the switch and unplug the electrical
cord before clearing hose.
Nested
Wands
1
Locate upper hose adapter on the back of the cleaner.
Remove nested wands from back of cleaner for easy
2
access to hose adapter tabs.
Press hose adapter tabs together and pull hose adapter
3
away from cleaner. The hose adapter will unscrew off
hose for easy access to debris if necessary.
Check for blockages at cleaner opening and in hose.
4
If no blockage is found, continue to step 5. If
blockage is found, clear and continue to step 11.
Hose
Adapter
Tabs
Locate lower hose adapter on the back of the cleaner.
5
Remove lower hose adapter from rear of cleaner by lifting
6
up and twisting.
Check for blockages in the hose and base hose. Flexing
7
the hose may help loosen any blockage. If no blockage is
found, continue to step 8. If blockage is found, clear and
continue to step 11.
s
Remove hood from cleaner and check for a
8
blockage in the brush roll area. Make sure the
hose inlet is clear.
After the blockage is found and cleared, replace
9
the hood on the cleaner.
10
Place lower hose adapter back into the base hose.
Install the upper hose adapter onto the back of
11
the cleaner, line it up with the cleaner opening
and push it against the cleaner until both tabs
Lower
Hose
Adapter
Base
Hose
15