Tv Monitor - RCA CC4371 User Manual

Record from a VCR or TV Monitor (continued)
Installation
1. Attach the white plug on one end of 2.
the optional audio/video cable to the
AUDIO OUT jack on the VCR (or
TV monitor).
Note: You need an optional audio/video
cable,
such
as VH83,
shown on page 61.
If the audio source has separate left and
right outputs, attach the audio plug to the
one labeled MONO. If one is not labeled
MONO, you may need a Y-adapter, as
shown on page 61 to record audio from
both the right and left channels.
.
Attach the yellow plug on the same
end to the VIDEO OUT jack on the
VCR (or TV monitor).
Attach the yellow plug on the other
end of the cable to the yellow VIDEO
jack and the white plug to the white
AUDIO jack on the side of the
camcorder.
4. Set the AV OUT/IN switch on the
camcorder to IN.
Recording Operation and How to Copy Tapes on the Camcorder
1.A. Camcorder connected directly to TV
monitor: Tum on TV and tune TV to
channel you want to record.
B. Camcorder Connected to VCR that is
connected to TV. Turn on VCR and
select the channel you want to record
(or place cassette you want to copy in
VCR).
Note: If you want to see what is being
recorded, turn on the TV and tune it to the
channel that you normally use to see the
signal from the VCR.
2. Set the AV OUT/IN switch on the
camcorder to IN.
3. Attach a power source to the
camcorder. Press and hold the small
button on the CAMERA/OFF/VCR
switch while you slide it to CAMERA.
4. Insert a cassette into the camcorder
with the safety tab intact.
5. Press REC/PA USE to start the
camcorder recording.
If you are copying a tape, start the
VCR playing.
6. Press REC/PAUSE on the camcorder
to stop recording when you are
finished.
Remember: Set the AV OUT/IN switch
on the camcorder to OUT for normal
recording on the camcorder.
49