Power Supply (150240); Replacing The Output Stacker Components; Output Stacker (D840590) - FARGO electronics HDP700 Series Technical Service And Maintenance Manual

FARGO Electronics Inc.
4.9.5 Power Supply
(150240)
Refer To Drawing 840161
Tools Needed
Torx T-10 Screwdriver, Phillips-head Screwdriver

4.10 Replacing the Output Stacker Components

4.10.1 Output Stacker
(D840590)
Refer to Drawing D840590
Tools Needed
Phillips-head Screwdriver, Torx T10 Screwdriver
4-48
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.
4. Remove the two screws (130314) from the Power Supply Cover.
5. Unplug the Power Supply Cable, the black wires leading into the white plug on the top of the
board.
6. Remove the cables from the power switch and the power plug.
7. Remove the four screws (130984) that secure the Power Supply.
8. Take the Power Supply from the printer.
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the four screws from the bottom edge of the Card Input Hopper Cover and the three
screws from the inside edge of the cover (on the left side) of the printer.
3. Lift the Card Output Hopper Cover off of the printer.
4. Remove the two screws from both sides of the Output Stacker.
5. Remove the screw from the base of the Output Stacker.
6. Disconnect the cable connectors.
7. Lift the Output Stacker from the Printer
HDP700 Series Card Printer