RCA F27731 Owner's Manual page 32

Standard VHS VCR (Not S-VHS)
(These connections allow you to record TV programs and play back tapes.)
Preferred Method
2-Way Signal Splitter**
for Areas with / (such as
RCA
#AH047)
Good Reception /
Incoming" I_'r_ //_ _ .......
Cable _ --
Coaxial Antenna Cables** _ _. [ . _r
(such as RCA #AH065G) ...... -Ira i _J
OUTTO TV
** These optional accessories
(one AH047-2-way splitter, two
AH065G-antenna cables, and one
AH077G-audio/video cable) are
available as a kit under #AVH500.
Back of VCR
Back of 13/
@=.@
Hl4q _ OUT - SELECT
Shown here is the preferred method of connecting a VCR to
your TV. This method uses a 2-way signal splitter to run
separate signals to the VCR and TV. This way you can view
either TV programs or VCR tapes and not be concerned about
the position of the VCR's TV/VCR switch.
Note: When connected this way, the audio/video connections from the
VCR to the TV are required in order for you to watch tapes being
played by the VCR and for picture-in-picture operation.
Operation:
*If the VCR is connected to INPUT 1 jacks as shown, select
channel 91 on the TV to view whatever the VCR is playing.
• If you connect a second audio/video device to INPUT 2, select
channel 92 on the TV to view whatever the second device is
playing.
Note: Youcan program your TV to automatically select the proper VCR
Simplified Method
Incoming
Cable
input channel (91 or 92) when you press the VCR 1 or VCR 2 button.
Details are on page 22.
Back of TV
@--@
HI-F1- OUT - SELECT
@.@
Back of VCR
Coaxial Antenna Cable*
(such as RCA #AH037)
Shown here is a simplified method of connecting a VCR to your
TV. The preferred method (using a 2-way signal splitter) is
shown above.
Note: The audio/videoconnectionsfrom the VCR to the TV are
optional; however, these additional connections usually produce a.
better-quality picture during VCR playback. These connections are
required, however, for stereo playback from stereo VCRs and for
picture-in-picture operation.
* Optional accessories are available from most RCA dealers and
electronics supply stores.
3O
Operation:
• If the VCR is connected to INPUT I jacks as shown, select
channel 91 on the TV to view whatever the VCR is playing.
• If you connect a second audio/video device to INPUT 2, select
channel 92 on the TV to view whatever the second device is
playing.
Note: Youcan program your TV to automatically select the proper
VCR input channel (91 or 92) when you press the VCR 1 or VCR 2
button. Details are on page 22.