RCA F25649TX51AA9 User Manual page 41

Using the
1. Press MEN[ (the TVMAhVMtkVUappears).
2. Highlight Cbanneland press OK on your remote control.
3. Highlight AJ_lo 7i¢ningand press OK.
4. Choose which channel you would like to set:
Set VCR 1 Channel Displays a list lhat lets you set tip the channel that tile
TV tunes to when you press the VCR1 button on tile remote.
Set VCR 2 Channel Displays a list that lets you set tip the channel that tile
TV tunes to when you press the VCR2 button.
Set DVD Channel Displays a list that lets you select the channel that tile
TV tunes to when you press the DVD but/on.
Set SAT/CABLE Channel Displays a list that lets you set up the channel
that the TV tunes to when you press SAT*CABLE.
5. Highlight the choice that matches the way you have tile component
connected to this TV, and press OK.
]lie choices and a brief explanation tifilow:
Not connected Choose this if you don't have this particular component
connected to tile TV, or if you don't want tile TV to automatically tune to the
correct channel when you're using this component.
Channel2 (SAT/CABLE only) Component (satellite or cable box) is
connected to the CABLE/ANTENNA jack on the back of the TV, and you want
the TV to tune to channel 2 when you press the SKI'- CABLE button on the
remote. Renfinder: make sure the cnmponent's Channel 2/3/4 switch is set to
channel 2. Usually this switch is on the back of the component.
Channel3 Component is connected to the CABLE/ANTENNA jack on the back
of the
TV,
and you want tile TV to tune to channel 3 when you press the
corresponding button on the remote. Reminder: make sure the cnmponent's
Channel 3/4 switch is set to channel 3.
Channel 4 Component is connected to the CABLE/ANTENNA jack on the
back of the TV, and you want the TV to tune to channel 4 when you press the
corresponding button on the remote. Reminder: make sure the cnmponent's
Channel 3/4 switch is set to channel 4.
Video Input Component is connected to the VIDEO jack on the back of the
TV and you want the TV to tune to VID (SVID if you used an S-Video cable)
Input Channel when you press the component button.
Note: You should choose thisjbr3'our VCR (/'.you connecled it to the TV
with audio/video cabte._.
39