Removing The Contents Of The Dust Container - Electrolux Z4009 Operating Instructions Manual

Confined areas: Use the crevice nozzle
for crevices, corners and radiators.
Dusting brush - Use for removal of
dust coverage on furniture and slatted
blinds.
REMOVING THE CONTENTS OF THE
DUST CONTAINER
Always operate the cleaner with the dust
container installed.
1. Remove the dust container by lifting
the handle on top of the container.
2. Remove the contents of the dust
container by pushing the orange-
coloured opening button.
3. Close the dust container lid until it
clicks.
4. Put the dust container back into the
cleaner.
6
5. Lock the dust container in place
by pushing down on the handle until
it clicks into place.
REMOVAL, CLEANING AND FITTING
THE PLASTIC CONE ASSEMBLY
To ensure there is no restriction of air
flow resulting in loss of suction after
the emptying of the dust container, it is
essential that the plastic cone is checked
for blockages.
REMOVAL OF THE PLASTIC
CONE SECTION
1. Place the dust container upside
down with the HEPA filter facing
away from you.
2. Open the dust compartment cover
flap by pressing the flap release
button.
3. The plastic cone assembly is located
on the left hand side. Twist the cone
assembly anti clockwise and lift out
the one assembly.
4. Check for residue build up,
if present, wipe clean and replace the
cone assembly in the locking position
in the dust container. Turn clockwise
to lock it in position (please note that
the cone assembly can only be fitted
one way.)
5. Close the flap and install the dust
container in the vacuum cleaner
body, ensuring it is locked into
position.