Opening The Door After The Programme Has Started; At The End Of The Programme - AEG LAVAMAT 64840 User Manual

Opening the door after the programme has started

First set the machine to pause by pressing the button
starts flashing and after some minutes goes off, the door can be opened.
If the door remains locked and the pilot light
machine is already heating, that the water level is above the bottom edge of the
door. In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the
machine off by turning the selector dial to
be opened (pay attention to the water level and temperature!).
After closing the door, it is necessary to select the programme and options again
and to press the button

At the end of the programme

The machine stops automatically. The pilot light of the button
10.1 and 10.2
be opened.
If a programme or an option that ends with water still in the tub has been
selected, the pilot light
the pilot light of the button
that the water must be emptied out before opening the door.
Follow the below instructions to empty out the water:
turn the programme selector dial to
●
select the DRAINING or SPINNING programme
●
reduce the spin speed if needed, by means of the relevant button
●
press button
●
when the programme has finished the display shows a flashing
●
10.2
goes off and the door can be opened.
Turn the programme selector dial to
laundry from the drum and carefully check that the drum is empty. If you do not
intend to carry out another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
8
.
go off and a flashing
10.2
illuminates, a flashing
8
goes off and the door remains locked to indicate
8
8
10.2
is on, this means that the
O
. After some minutes the door can
0
will appear on the display. The door can
0
O
O
to switch the machine off. Remove the
Use
. If the pilot light
8
, the pilot lights
will appear on the display,
0
. The pilot light
19
10.2