Table of Contents
Advertisement
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked
If required, pour fabric softener into the
compartment marked
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by means of
the programme selector dial
Turn the programme selector dial to the
required programme. The green light of button
8
starts to flash. It can be turned either
clockwise or anticlockwise.
On position «O» the programme is reset and
the machine is switched OFF.
At the end of the programme the selector
dial must be turned to position «O», to
switch the machine off.
ATTENTION!
If you turn the programme selector dial to ano-
ther programme when the machine is working,
the red pilot light of button
and the message Err is displayed on the dis-
play to indicate a wrong selection. The machi-
ne will not perform the new selected program-
me.
Select the spin speed or the Rinse Hold
option by pressing button
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate. The light
corresponding to your selection will light up.
Select the desired option by pressing
3
4
6
buttons
,
and
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before depressing the button
.
(the amount used
(1)
8
will flash 3 times
2
8
.
For the compatibility of the options with the
washing programmes, refer to the section
«Programmes table».
Select the delayed start by pressing the
button 10
Press this button to select the required delay.
The selected delay time value will appear on
the display for a few seconds, then the duration
of the programme will appear again.
You must select this option after you have set
the programme and before you press the
8
button
.
You can cancel the delay time at any moment,
before you press button
pressed it, and you wish to cancel the delay
time, proceed as follows:
• set the washing-dryer to PAUSE by pressing
8
button
;
10
• press the button
appear the symbol «
8
• press button
again to start the programme.
IMPORTANT!
The selected delay can be modified only after
you have turned the programme selector dial to
the «O» position and after you have selected
the programme again.
Note!
The Delay Start cannot be selected with
«Drain» programme.
Start the programme by pressing button
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing.
9
The pilot light
illuminates to indicate that the
appliance starts operating and the door is
locked. If a delayd start has been selected, the
display shows the countdown.
IMPORTANT! If an option which is not
compatible with the set wash programme is
8
. If you have already
once. On the display will
».
0'
15
8
Hide quick links:
Advertisement
Table of Contents
