Grasscatcher A Ssembly - Yard-Man 469 Operator's Manual

Aftermoving thehairpin clip,insert t hecarriage bolt
fromhardware p ackintheupper h oleonthehandle
mounting b racket a ndsecure withplastic wingnut
fromthehardware pack. R epeat onotherside.
Handle Mounting
Wing Nut
2
Haiq:"
Clip
4__Carriage Bolt
Hairpin
Clip
Pin
Figure 4
Fasten the cable to the lower handle with the two
cable ties found on the lower handle. Pull the cable
ties tight and trim off the excess. See Figure 5.
Cable Tie
Post on
Figure 5
Attaching S tarterRope
• The rope guide is attached to the right side of upper
handle. Loosen the wing nut which secures the
rope guide. See Figure 6.
Starter\ Upper Handle
Rope _
Nut
GrassCatcher A ssembly
NOTE: Make certain the grass bag is turned right side
out before assembling (warning label will be on the
outside).
Partsfor softgrass bag
1. Frame Assembly
2. Bag
Assemblingsoft grass bag
• Place the bag over the frame (black plastic side is
the bottom of bag). Slip the openings in the side of
the plastic channels on the bag over the hooks on
the grass catcher frame.
• Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 7B.
All of the plastic channels except the center top of
the bag attach from the outside of bag. The center
top of the bag attaches from inside the bag.
Frame
Assembly
/
ag
Frame
Plastic
Channels
Figure 7
Rope
Guide
\ Lower
Handle
Figure 6
With the spark plug wire disconnected and
grounded, hold the blade control bar against the
upper handle, and pull the starter rope out of the
engine. Release the blade control bar. Slip the
starter rope into the rope guide. Tighten the wing
nut.