Table of Contents
Advertisement
WARNING
Read, understand,
and follow all instruc-
tions and warnings
i on the machine and
in this manual before
, operating.
Never attempt to
make any adjust-
i ments while the
_engine is running,
i except where speci-
i fied in operator's
_manual.
///
Figure 13
Figure 14
Figure 15
if
Shift Cable
If the full rangeof speeds(forwardand reverse)cannot
be achieved,referto the figureto the left and adjustthe
shiftcable as follows:
1, Placethe shiftleverin the fastest forwardspeed
position,
2, Loosenthe hex nuton the shiftcable indexbracket,
See Figure13.
3. Pivotthe bracketdownwardto take up slack in the
cable,
4, Retightenthe hex nut,
5. Checkforcorrectadjustmentbeforeoperatingthe
snowthrower.
Chute Control
Oncea seasonor every 25 hoursof operation,whichever
is earlier,checkwhetherthe four-waychutecontrol
T M
cableshaveslackened,If the chute doesnot rotate
fully or its pitch cannotbe movedup or down,the chute
controlcableswill haveto be adjusted,
Toadjustthese cables,proceedas follows:
1. Totightencable, loosenthe top nutand tightenthe
bottomnuton thecable.
2. Adjustequallyon both sidesby workingon both
cables,See Figure14,
Drive Control & Shift Lever
Whenthedrivecontrol is releasedand in thedisengaged
"up"position,the cableshouldhavevery little slack. It
shouldNOTbe tight.
Checktheadjustmentof the drivecontrolas follows:
1, With the drivecontrol released,pushthe snowthrower
gentlyforward,The unit shouldroll freely.
2, Engagethe drivecontrol and gentlyattemptto push
the snowthrowerforward.Thewheelsshouldnot turn.
Theunit shouldnot roll freely.
3, With the drivecontrol released,movethe shift lever
back and forth betweenthe R2 positionand the F6
positionseveraltimes, Thereshouldbe no resistance
in theshift lever,
4, If anyof the abovetests failed, thedrivecable is in
need of adjustment,Proceedas follows:
5, Loosenthe lowerhex nuton the drivecable bracket,
See Figure15,
6, Positionthe bracketupwardto providemoreslack(or
downward to increasecabletension),
7. Retightenthe lowerhex nut,
Youcan alsocheckthe adjustmentas follows:
1, With the snowthrowertipped forward(be certainto
drain gasolineor place plasticfilm underthe gascap if
the snowthrowerhasalreadybeenoperated),remove
the framecoverunderneaththe snow throwerby
removingthe self-tappingscrews,Referto Figure20
on page 17.
14
Hide quick links:
Advertisement
Table of Contents
