Secure The Drain Hose; Level The Washer; Complete Installation - Whirlpool WFW9250WL02 Use & Care Manual

Drain h ose must b esecured tostop thehose from moving w hen
water i spumped out.Ifthedrain hose moves, water m ay endup
onthefloor.
1. Drape t hepower cord over t hewasher top.
2. Move thewasher toitsfinal l ocation.
3. Place t hedrain hose inthelaundry tuborstandpipe asshown.
NOTES:
4.
See illustrations A and B.
B
II
C
Do not force excess drain hose back into the rear of the
washer.
To avoid siphoning, do not seal or put more than 4V2"
(114 mm) of the drain hose into drainpipe or standpipe.
If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
Proper foot to floor contact and leveling your washer avoids
excessive noise and vibration.
NOTE: Installing washer on soft floor surfaces, such as carpets or
surfaces with foam backing, is not recommended.
1. Slide the washer to its final location.
2. Check that all four feet are in firm contact with the floor.
3. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side then front to back.
4.
5.
Make sure all four feet are in firm contact with the floor. Then
check that the washer is perfectly level (use a level). Repeat
steps 1-3 until washer is level.
After the washer is level, and all four feet are in firm contact
with the floor, use a 9/_6"(14 mm) open-end wrench to turn the
Iocknuts on the feet, tightly against the washer cabinet.
IMPORTANT: All four Iocknuts on the feet must be tightened.
If the Iocknuts are not tight against the washer cabinet, the
washer may vibrate.
6. The washer should not move front to back, side to side, or
diagonally when pushed on its top edges.
7. Confirm the levelness of the washer.
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that both water faucets are on.
6. Check for leaks around faucets and inlet hoses.
7.
8.
9.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug into a grounded 3 prong outlet.
Read "Washer Use."
To test and to clean your machine, make sure that there are no
clothes in the washer and add one AFFRESH _e washer tablet
to the washer drum. Press POWER, the CLEAN WASHER with
AFFRESH
TM
cycle and then press START/PAUSE. This cycle
will take approximately 50 minutes to complete. Allow the
washer to complete the entire cycle without interruption.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wooden block and adjust the front feet height
moving the hexagonal plastic part as necessary. Repeat to
adjust back feet.
10