Normal Sounds - Whirlpool Cabrio WTW6200VW0 Use & Care Manual

To change the Delay Wash time:
• Press PAUSE/CANCEL.
• Press DELAY WASH to select the desired delay time.
• Press START to begin the countdown.
To cancel Delay Wash:
Press START again to begin the cycle right away or press
PAUSE/CANCEL twice.
(y_y_._2_,_ 5 _._:t _,_._
Power
Press POWER to turn the washer on or off.
Use these pads to select the desired options for your wash cycle.
@
DEEP CLEAN
®
EXTRA RINSE
®®
FABRIC ENDOFCYCLE
SOFTENER SIGNAL
DISPENSER
Deep Clean
This option provides enhanced cleaning action for tough stains.
The Heavy Duty cycle automatically includes Deep Clean.
Choosing Deep Clean will add approximately 10 minutes to a
cycle. Deep Clean should be started on a dry load only and
cannot be selected after the tub has started filling with water.
Deep Clean may be selected as an option with other cycles. See
table for details.
Cycle Deep Clean
(Adds time to the wash cycle)
Whitest Whites Option
Heavy Duty Default
Normal Option
Casual/Perm Press Option
Colors/Darks Option
Delicate Option
Handwash/Wool Option
Rinse & Spin Not available
Drain & Spin Not available
Extra Rinse
An extra rinse can be used to aid in the removal of soil,detergent
or bleach residue from garments. This option provides an
additional rinse with the same water temperature as the first
rinse. This is the default rinse setting for the Whitest Whites cycle.
Fabric Softener
The Fabric Softener option must be selected if liquid fabric
softener is added to the fabric softener dispenser. This option
flushes the dispenser at the right time in a deep water rinse for
optimal distribution.
End of Cycle Signal Volume
The End of Cycle Signal produces an audible sound when the
wash cycle is finished. This signal is helpful when you are
removing items from the washer as soon as it stops. Select On or
Off.
Start
Press START to start your washer after a cycle has been
selected. Be sure all desired Modifiers and Options have been
selected. The lid must be closed for the washer to start.
%1ART
Pause/Cancel
Press PAUSE/CANCEL once to pause or stop the washer at any
time. Press PAUSE/CANCEL once to unlock the lid and add a
garment. Press START to complete the cycle from where it was
stopped. Press PAUSE/CANCEL twice to stop the wash cycle.
The washer will then drain and turn off.
!
LidLock
Lid Lock
When the Lid Lock status light glows, the washer lid is locked.
NOTE: You must wait until the Lid Lock Light turns off before the
lid can be opened.
Your new washer may make sounds your old one didn't. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
If you select the Deep Clean option, you will hear a spin/spray
noise at the start of the cycle.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
During wash and spin
This washer does not have a transmission. The motor provides
direct drive for agitation and spin. You will hear sounds that are
different from those of a conventional washer.
16