Restart System - D-Link DGS-3312SR Product Manual

The following options are available to perform a factory reset:
• Reset − Returns all configuration settings to the factory default settings except the Switch's stacking mode, IP
address, subnet mask, and default gateway settings.
• Reset Config − Returns all configuration settings to the factory default settings except the stacking mode
configuration, but does not save the settings or reboot the Switch. If you select this option the Switch
configuration will be returned to the factory default settings for the current session only. When the Switch is
rebooted, it will return to the last configuration saved to the Switch's NV-RAM using the Save Changes option.
• Reset System − Returns all configuration settings to the factory default settings, but does not save the settings or
reboot the Switch. If you select this option the Switch configuration will be returned to the factory default settings
and then saves the factory default configuration to the Switch's NV-RAM. The Switch will then reboot. When the
Switch has rebooted, it will have the same configuration as when it was delivered from the factory.
Select the reset option you want to perform and click on the Apply button.

Restart System

The following window is used to restart the Switch. Access this window by clicking on the Restart System link in the
Maintenance folder.
Click the Yes after "Do you want to save the settings?" to instruct the Switch to save the current configuration to non-
volatile RAM before restarting the Switch.
Clicking the No option instructs the Switch not to save the current configuration before restarting the Switch. All of the
configuration information entered from the last time Save Changes was executed will be lost.
Click the Restart button to restart the Switch.
DGS-3312SR Gigabit Layer 3 Switch
Figure 3- 9. Factory Reset to Default Value window
28