Basic Setup; Switch Information - D-Link DES-3326SRM - Switch - Stackable Product Manual

D-Link DES-3326S Layer 3 Switch

Basic Setup

The subsections below describe how to change some of the basic settings for the Switch such as changing IP settings and
assigning user names and passwords for management access privileges, as well as how to save the changes and restart the
Switch. The menus to perform these tasks are located in the Basic Setup folder. The hyperlinked menu buttons in this folder
include: Switch Information, Basic Switch Setup, Serial Port Settings, Port Configurations, Port Security Settings,
Traffic Segmentation Table, User Accounts, Factory Reset, Save Changes and Restart System. Most of these menus and
the subdirectorys located in the Basic Setup folder are discussed in later chapters. The subdirectories include: SNTP Settings,
Network Management, Switch Utilities and Network Monitoring.

Switch Information

The first page displayed upon logging in presents the
System Information menu. This page can be accessed at
any time by clicking the Switch Information button in the
Basic Setup folder.
The System Information page displays general information
about the Switch including its MAC Address, Hardware
Boot PROM and Firmware versions, and installed module
information. To view the same information using the CLI
interface use the command show switch (this will also
display IP settings information).
Figure 3- 2. Switch Information menu
34