Denon PMA-2000 IV - Amplifier Service Manual page 35

SCHEMATIC DIAGRAMS (3/3)
1 2
NOTICE
ALL RESISTANCE VALUES IN OHM. k=1,000 OHM M=1,000,000 OHM
ALL CAPACITANCE VALUES IN MICRO FARAD. P=MICRO-MICRO FARAD
EACH VOLTAGE AND CURRENT ARE MEASUERD AT MO SIGNAL INPUT
CONDITION.
CIRCUIT AND PARTS ARE SUBJECT TO CHANGE WITHOUT PRIOR
NOTICE.
3 4
WARNING:
Parts marked with this symbol have critical characteristics.
Use ONLY replacement parts recommended by the manufacture.
CAUTION:
Before returning the unit to the customer, make sure you make either (1) a
leakage current check or (2) a line to chassis resistance check. If the leakage
current exceeds 0.5 milliamps, or if the resistance from chassis to either side
of the power card is less than 460kohms, the unit is defective.
WARNING:
DO NOT return the unit to the customer until the problem is located and
corrected.
5
6
PMA-2000 IV R
7 8
A
B
C
D
+ B LINE
- B LINE
Lch SIGNAL LINE
Rch SIGNAL LINE
E
SCHEMATIC DIAGRAMS (3/3)
1U-3433 FLAT AMP UNIT
25