Grasscatcher Assembly - Troy-Bilt 436 Operator's Manual

21" rear & side discharge mulching
Hide thumbs Also See for 436:
Table of Contents

Advertisement

Insert post of cable ties that are on lower handle
into the holes provided on the lower handle. The
holes may be on the inside or outside. Pull cable
ties tight and cut off the extra. See Figure 5 below.
Cable
Tie
\
\
Post on
Cable Tie-
Figure 5
Attaching StarterRope
The rope guide is already attached to the right side of
the lower handle of your mower. See Figure 6.
With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope up to the
rope guide. See Figure 6.
Slip the rope through the rope guide as shown
below. Tighten the wing nut holding the rope guide
to the lower handle.
Slip rope into
rope g%
Wing Nut
Figure 6
GrassCatcher Assembly
NOTE: Make certain the grass bag is turned right side
out before assembling
(warning
label will be on the
outside).
Partsfor Soft GrassBag
1.
Front Frame
2.
Rear Frame
3.
Bag
AssemblingSoftGrassBag
Join the rear frame and front frame assembly as
shown in Figure 7 A.
Rear
Frame
Place the bag over the frame (black plastic side is
the bottom of bag). Slip the openings in the side of
the plastic channels on the bag over the hooks on
the grass catcher frame.
Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 7 B.
All of the plastic channels except the center top of
the bag attach from the outside of bag. The center
top of the bag attaches from inside the bag.
]
Frame
Hook
Plastic
Channels
Note: Bag-Fill Indicator, shown
here, is an optional item
Figure 7
Attaching GrassCatcher
If your mower is equipped with a mulching plug, and
it is in place on the moweq lift the rear discharge
door and remove the rear mulching plug from the
mower. See Figure 8.
Rear
Mulching
j
Plug
\
Figure 8
NOTE: Make sure that the cables are routed to the
outside of the handle when attaching the grass catcher.
Lift the rear discharge door.
Place the hooks of the grass catcher into the slots in
the handle bracket assemblies on both sides. See
Figure 9. Release the rear discharge door.

Advertisement

Table of Contents
loading

Table of Contents