Clutch/Brake Pivot; Steering Sector Gear; Steering Shaft; Steering Drag Link - Snapper LT160H42FBV Operator's Manual

Section 3 - MAINTENANCE
3.3.4. TRACTOR LUBRICATION
(Continued From Previous Page)
3. Clutch/Brake Pivot
The clutch/brake pivot is located on the L.H.
underside of the tractor and is lubricated with one
shot of general purpose grease. See Figure 3.7.
PIVOT LUBRICATION
FITTING
DRAG LINK
LU BRICATION
_/ POINT
FIGURE 3.9
7. Steering Tie Rod
Lubricate both ends of steering tie rod with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.10.
LUBRICATE
BOTH ENDS
OF TIE ROD
FIGURE 3.7
4. Steering Sector Gear
Lubricate with a light coat of general purpose grease.
See Figure 3.8.
LUBRICATE
f"-.. LUBR,CATE
STEERING
SHAFT GEAR
FIGURE 3.8
5. Steering Shaft
Lubricate steering shaft wear points with a light coat
of 30 wt. Motor oil.
6. Steering Drag Link
Lubricate both ends of steering drag link with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.9.
FIGURE 3.10
8. Park Brake Lever
Using 30 wt. motor oil. lubricate the park brake lever
mechanism pivot points, which are located on the left
hand underside of tractor. See Figure 3.11. Lubricate
mechanism with a thin coat of 30 wt. motor oil.
/
BRAKE
LEVER
LUBRICATE
COMPONENTS ON
UNDER OF TRACTOR
FIGURE 3.11
9. Deck Lift Mechanism
Lubricate all wear and pivot points of the deck lift.
13