Clutch/Brake Pivot; Steering Sector Gear; Steering Shaft; Steering Drag Link - Snapper LT160H42GBV, 2LT160H42GBV2, LT180H48GBV2 Safety Instructions & Operator's Manual

Section 3 - MAINTENANCE
3.3.4. TRACTOR LUBRICATION
(Continued From Previous Page)

3. Clutch/Brake Pivot

The clutch/brake pivot is located on the L.H.
underside of the tractor and is lubricated with one
shot of general purpose grease. See Figure 3.6.
FIGURE 3.6

4. Steering Sector Gear

Lubricate with a light coat of general purpose grease.
See Figure 3.7.
FIGURE 3.7

5. Steering Shaft

Lubricate steering shaft wear points with a light coat
of 30 wt. Motor oil.

6. Steering Drag Link

Lubricate both ends of steering drag link with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.8.
CLUTCH/BRAKE
PIVOT LUBRICATION
FITTING
LUBRICATE
STEERING
SECTOR GEAR
LUBRICATE
STEERING
SHAFT GEAR

7. Steering Tie Rod

Lubricate both ends of steering tie rod with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.9.

8. Park Brake Lever

Using 30 wt. motor oil, lubricate the park brake lever
mechanism pivot points, which are located on the left
hand underside of tractor. See Figure 3.10. Lubricate
mechanism with a thin coat of 30 wt. motor oil.
LUBRICATE
COMPONENTS ON
UNDERSIDE OF
TRACTOR

9. Deck Lift Mechanism

Lubricate all wear and pivot points of the deck lift.
14
DRAG LINK
LUBRICATION
POINT
FIGURE 3.8
LUBRICATE
BOTH ENDS
OF TIE ROD
FIGURE 3.9
PARK BRAKE
LEVER
FIGURE 3.10