Sound Volume; Changing Channels - Sharp AQUOS LC-15S5U Operation Manual

Basic Operation (Continued)
Sound Volume ....
a To adjust the volume
POWER
0
0(i)(i)
(g) (i)
4UTE VOL CH IPI_UT
o+A , A o
Press VOL (+) to increase the sound volume
The bar indicator shifts right.
VOLUME
50 UlIlUUliUlllIlIIJllIllilIlIllalIIUllUlli .........
Press VOL (-) to decrease the sound volume
The bar indicator shifts left
L VOLUME 10 I11111111! .............................................
m To mute the sound
o Press MUTE to temporarily turn off the sound
The MUTE mark n_l_ is displayed for' 4 seconds
Changing Channels ....
OQO
QOQ
OQQ
You can select channels using Channel Select or
CH (^)l(v).
I
• Tis LCD TV set allows you to select up to 125 channels ]
Mhto 125). To select a channel, enter a 2-or 3-digit number.
I
m Using Channel Select
When selecting the channel using Channel Select,
complete input of the channel number' by holding down the
button for the last digit for a moment
To select a 1- or 2-digit channel number (e+g,,Channel 5):
Complete the following procedure within 4 seconds
:1' Press the _ button
0-
Press the _ button
5
Press MUTE or VOL (+)/(-) to turn the sound back to
the previous ieve[
The mute function is automatically turned off when any
of the following buttons are pressed: POWER, MUTE,
VOL(+)I(-) or MTS
l VOLUME t0 Illlilllll .............................................
• When VOL (+)I(-) is pressed in the Mute mode, the sound turns
on and the volume indicator is displayed.
• The Mute function is canceled when POWER is pressed
a To select MTS (Multichannel TV Sound)
1
i12
_LU(, _,
_: IL:: ¸
Press MTS to display the MTS screen
Press MTS to select the MTS settings
STEREO: stereo audio
SAP: secondary audio program
MONO: monoptlonic audio
l> STEREO<ON A IR
SAP <ON At R
MONO
• "ON AIR" appears when a STEREO or SAP broadcast is being
aired
• When selecting a 1*digit channel number do not fail to press the
button first
To select a 3-digit channel number (e.g,, Channel 115):
Complete the following procedure within 4 seconds
1
Press the (_) button
2
Press the _ button
1t-
;3
Press the _ button
i :i
115
• The 3-digit channel number can be selected only when the
receiving mode is set to "CABLE" in "CH SETUP", (For details on
setting the receiving mode, see page 24.)
f
Changing channels with CH (A)/(V) on the remote control
Air: PressCH(/,.) andthe channels changein the ordershownbelow:
2-_ 3--+ _ 68 +_" 69 "e 2 _" 3 -*
PressCH(v} andthe channe{s changein the ordershownbelow:
3 -> 2 -_,69 -_ 68 _ _ 3 _, 2
Cable:PressCH(/,,) andthe channels changein the ordershownbelow:
1-+2_3-_, -_ 125-+ 1 -+- 2-_ 3 _
PressCR(v} andthe channels changein the ordershownbelow:
,, Using FLASHBACK
• Press FLASHBACK to switch the currently tuned
channel to the previously tuned channel
= Press FLASHBACK again to switch back to the currently
tuned channel