Sansui HDLCD2600A Owner's Manual page 16

26" wide tft lcd television with digital tuner
Table of Contents

Advertisement

Connections to other equipment
To connect
an audio
system
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the
TV's remote control.
To control the audio, turn on the TV and the stereo amplifier, and turn off the-rv's built-in speakers (see "Turning
off the built-in speakers" on page 25).
Left side of the TV
NOTE:
i
=
Amplifier
I
I
[]
BBBBB
ooo
0 ooo
To Audio (L) Input -'_To
/
Audio cord (not supplied) /
Audio (R) Input
To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set
above 0 (zero).
For example, if the volume of the TV is set to 0, you wilt not be able to hear any sound, even if the volume of the
amplifier is at its highest level.
To connect the LCD TV to a PC (Personal
Computer)
Before you connect this LCD TV to your PC, change the adjustment of your PC's Resolution and Refresh rate
(60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA
connector PC MONITOR on the back of the LCD TV. Attach the connectors firmly with the screws on the plug. In
case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to
the AUDIO connector of the PC/HDMI-1 AUDIO IN jack of the LCD TV.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The LCD TV can operate as the computer monitor.
Left side of the LCD TV
MI
p
HDMk_ II III
HDMMII II
FC
MONITOR
To PC MONITOR IN
To PC/
HDMI-1
AUDIO
IN jack
Audio cord (not supplied)
PC
1
Monitor Display modes
MODE
Resolution
Refresh rate
VGA
640x480
60Hz
VGA
720x400
70Hz
SVGA
800x600
60Hz
XGA
1024x768
60Hz
WXGA
1280x768
60Hz
WXGA
1280x720
60Hz
WXGA
1360x768
60Hz
To return to normal mode
Press INPUT SELECT again.
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents