Table of Contents
Advertisement
Available languages
Available languages
MEETING
iNSTALLATiON
REQUIREMENTS
Electrical supply
120 Volt 60 Hz 15 AMP fuse or circuit breaker
Individual branch
circuit serving only your washer is recommended.
Your washer is equipped
with a power cord.
Z_
Never use an extension
cord.
CAUTION
Grounding
ELECTRICAL GROUNDING IS REQUIRED FOR THIS APPLIANCE.
This appliance
must be grounded.
In the event of malfunction
or breakdown,
grounding
will
reduce the risk of electric shock
by providing
a path of least resistance
for electric current.
This appliance
is equipped
with a power cord having a three-prong
grounding
plug for use in a
properly
installed and grounded
outlet.
The plug must be plugged
into an appropriate
outlet that is properly
installed and grounded
in
accordance
with all local codes and ordinances.
,4X
Improper
connection
of the equipment-grounding
conductor
can result in a risk of electrical
.......
_
shock.
Check with a qualified electrician
or serviceman
if you are not sure whether
the
appliance
is properly
grounded.
Do not modify the plug provided with the appliance.
If it
does not fit the outlet, have a proper outlet installed by a qualified electrician.
IMPORTANT SAFETY PRECAUTIONS
To prevent unnecessary
risk of fire, electrical
shock, or personal
injury, all wiring and
grounding
must be done in accordance
with the National Electrical Code ANSI/FNPA,
No.
70 Latest Revision and local codes and ordinances.
It is the personal responsibility
of the
appliance
owner to provide adequate
electrical
service for this appliance.
Z_
Never connect
the ground
wire to plastic plumbing
lines, gas lines, or hot water pipes.
CAUTION
Wat e r
To correctly
fill your washer in the proper amount
of time, water
pressure of 20-116
psi (137-
800 kPa) is required.
Water pressure less than 20 psi (137 kPa) may cause water valve failure, may not allow the water
valve to shut off completely,
or may extend the fill time beyond what your washer
controls allow,
resulting
in your washer turning
off. A time limit is built into the controls
to prevent flooding
if a
hose becomes
loose.
The water faucets
must be within 4 ft. (122 cm) of the back of your washer to match the inlet
hose provided with your washer.
_
ccessory
inlet hoses are available
in various lengths up to 10 ft. (305 cm) for faucets
that
are further away from the back of your washer.
To avoid the possibility
of water damage:
Have water faucets
easily accessible.
Turn off faucets when the washer
is not in use.
Periodically
check that there is no leakage from the water inlet hose fittings.
Check all connections
at the water valve and faucet for leaks.
WARNIN_
Drain facility
If you use a standpipe,
the recommended
height of the standpipe is 18 in (46 cm). The drain hose
must be routed through the drain hose dip to the standpipe.
The standpipe must be large enough to
accept the outside diameter of the drain hose. The drain hose is attached the factory.
setting up your washer
13
WF361
363 365-02832J-02
£N.indd
Sec5:13
2012-07-24
C-8:08:40
I
Advertisement
Table of Contents
