B Changing Channels - Samsung Series6 650 PN50A650 User Manual

If you want to reset this feature...
1 Press the MENU button to display the menu.
Press the ,& or T button to select Setup, then press the ENTER button.
2 Press the ENTER button to select Plug & Play. For further details on setting
up options, refer to the pages 16~17.
;'_ The Plug & Play feature is only available in the TV mode.
Changing Channels
_the Channel Buttons
1 Press the CH [_3 or CH _ button to change channels.
When you press the CH [_ or CH _ button, the TV changes channels in
sequence. You wilt see all the channels that the TV has memorized.
(The TV must have memorized at least three channels). You wilt not
see channels that were either erased or not memorized. See page 20 to
memorize channels.
To increase the channel number, turn the wheel clockwise when the Channel
Display is displayed. To decrease the channel number, turn the wheel
counterclockwise.
illi ................... _ _,00=E ................... _llii
h___l -b_J
_the Number Buttons
Press the number buttons to go directly to a channel. For example, to select
channel 27, press 2, then 7.
The TV wilt change channels when you press the second number.
;'_ For quick channel change, press the number buttons, then press the ENTER
button.
;'_ You can press number buttons on Remote control for direct channel access,
press the same Number button again to switch between digital and analog
TV channels broadcast by the same station.
Using_the "-" Button
The "_" button is used to select stations that broadcast a digita! signal.
1 For example, for Channel 7-1, press 7, then _, then 1.
HD indicates the TV is receiving a Digital High Definition signal.
SD indicates the TV is receiving a Standard Definition signal.
;'_ For quick channel change, press the number buttons, then press the ENTER
button.
_the PRE-CH Button to select the Previous Channel
Use the number buttons to quickly tune to any channel.
1 Press the PRE-CH button. The TV will switch to the last channel viewed.
To quickly switch between two channels that are far apart, tune to one
channel, then use the number button to select the second channel.
Then use the PRE-CH button to quickly alternate between them.
cscs1
= f I =
i t tLJ i
I _ IJ i
i Ir-xqr-_ r-sql_ i
i I I i
..... .....
1 !.....
..... ....
..... li i! .....
I BN68 01532A Engindb 18
2008 04 18 _ 8:37122