Input Signal Setting
The receiver defaults to the most convenient
settings
for
your easiest use (see table).
By default,
SAT (satellite)
is set to analogue
input.
If you
wish to change the input
formats, follow
the steps below:
1. Press SOURCE on the main unit until SAT appears on the
display or press the SAT source buttons
on the remote
control.
2. Press DIGITAL on the remote control
to toggle among
optical/coaxial/analog
to match your connection.
Your
selection
will be stored automatically.
Every time you press the source button,
the input setting
(e.g. SAT/ANL) will be shown on display for a few seconds.
i
AVAILABLE INPUT
ANL/Optical/Coaxial
Built-in
ANL/- / -
Digital Input: Coaxial (COAX) I Optical (OPT)
Select this setting to play digital signals from a DVD, CD, LD
player, or SAT, (SAT mode only)
CAUTION!
//_
DO NOT CONNECT A LD PLAYER WITH RF
COAXIAL OUTPUT TO YOUR COAXIAL INPUT.
Analog Input
Select this setting to play analog signals from a cassette
deck, VCR or SAT.