RCA L42FHD2X48 User Manual page 75

6.When allcodes have been searched, theCANCEL button blinks rapidly t oindicate f ailure, and theremote
returns t onormal operation.
Note; If you accidentally passed the code before saving it, use the le_ arrow to backtrack througl_ the codes. Use
the riglTt arrow to go f7Jrward througl7 the codes again. Once the left or rfght arrow has been pressed, the search
mode changes to Manual Code .fearch.
Using
the Remote
Once the remote has been programmed successfully, it is ready to operate your components.
To operate the component:
1. Press the component button (SAT/AUX or DVD) to set the remote to control the component. For
example, press DVD to control your DVD player.
2. Press ON.OFF to turn the component ON or OFE
3. Use the remote buttons that apply to that component.
Modes of Operation
The button that corresponds to the mode the remote is in illuminates when you press any button that
applies to the component. For example, if you're in TV Mode and you press the VOL+ button, the TV button
lights up. This tells you that the command to increase the volume is being sent to the T_.
Note: The remote control may not be compatible vvithall bonds and models of components.
Manual Reset
The Manual Reset is used to reset the remote settings to default.
Note; The reset can also be accomplished by repl_._clngd_ebatteries; however replacing the batteries does not
always cause a reset. You can perform a manual reset by following these steps;
1. On your remote control, simultaneously press the V-Chip, ON.OFF and MUTE buttons.
2. The CANCEL button will blink slowly to indicate success, and the remote control returns to normal
operation.
Using the Remote Control
23